44 45
M aintenanc e
B ow l U nit
(Approximately daily)
B ow l U nit
(Approximately daily)
( C ontinu ed )
B ow l U nit
* 1
(Approximately once a month)
Toilet brush
Neutral toilet
detergent
Strongly acidic cleaners or strong alkaline cleaners
Cleaners containing abrasive compounds
Fluoride-based detergent
(
Containing hydrogen uoride or ammonium uoride
)
Wire brush
Abrasive nylon scrubbing brush
1
Switch the breaker on the distribution board to OFF.
Clean with a toilet brush or a similar tool.
T h e w ater l ev el in th e b ow l u nit c an b e l ow ered to perf orm c l eaning or m aintenanc e.
(Switch the breaker on the distribution board to ON.)
<"Bowl unit cleaning"> Operate with the buttons on the back side of the remote control.
Press
Select [MANUAL CLEANING] Press
Select [BOWL CLEANING ON/OFF] Press
The water in the bowl unit ows, and then drains. After that, the water level drops for about 50 seconds.
C l ean ins id e th e b ow l u nit.
The water in the bowl unit drains, and then returns to its original level.
T o s top part w ay th rou g h , pres s ( " S topping " b u tton) on th e f ront s id e of th e rem ote c ontrol .
Switch the breaker on the distribution board to ON.
The "Power" LED lights up.
" ew ater+ " m is t c an b e s pray ed to f inis h c l eaning or m aintenanc e.
(It cannot be used when the wand is out or when you are sitting on the toilet seat.)
<"Manual CLEAN"> Operate with the buttons on the back side of the remote control.
Press
Select [MANUAL CLEANING] Press
Select [MANUAL CLEAN] Press
("ewater+" mist is sprayed on the bowl unit.)
2
3
I f th e b ow l u nit is c l og g ed
• Using plunger or similar, provide 10 cm or more clearance between the
top of the bowl unit and the water surface. Use commercially available
tools that are made for unclogging the bowl unit.
(May cause overflow of dirty water and water damage.)
I f th e f l oor is d irty
• Clean it with a well wrung cloth.
(Not cleaning the floor may cause stains or corrosion.)
• Sitting is recommended to reduce splashing caused by standing and
urinating.
M aintenanc e
Bowl Unit
Vinyl sheet, etc.
Keep 10 cm or
more
Attention!
Be careful not to expose the top unit or the gap between it and the bowl unit to water.
(May cause water overflow into the room.)
Do not use any water repellant, stain-proofing cleaner or surface coating agent.
These products would not damage the porcelain surface, but they may cover the porcelain surface and reduce the effect
of the built-in stain prevention technology.
●
To preserve the performance of the photocatalyst cleaning, clean the toilet bowl surface with a toilet brush, etc. using
commercially available hydrochloric acid-based or inorganic acid-based detergent.
*1 Other than the CS900***
To Next Page
Loading...
Need help?
General