52 53
R ef erenc e
You can ush the toilet with the hand lever (for ushing in case of power outage).
* Pulling the hand lever does not ush the toilet when the power is supplied.
When testing the operation, switch the breaker on the distribution board to OFF.
Remove the rear cover of the main unit while
pushing outward on the portion indicated by
the
in the figure.
Pull the hand lever to where it stops.
(about 30 seconds).
The water surface in the bowl rises.
1
2
W h at to D o?
If water does not ow during a power outage (when water failure hasn't occurred) (Continued)
If the water does not ow due to a power outage (when water failure hasn't occurred)
When the beep sound is made and water
supply stops, release the hand lever and
return it to its original position.
The toilet flushes.
* You cannot flush the toilet for about 60 seconds after
flushing it or releasing the hand lever halfway.
Wait at least about 60 seconds and then flush the toilet
again.
Install the rear cover of the main unit.
Insert the cover tabs securely.
(May cause damage to the rear cover.)
Attention!
When power is restored, be sure to perform a full flush.
(To prevent waste from remaining in the discharge pipe.)
* You can flush the toilet with a bucket. (Page 56)
3
4
Hand lever
(For ushing in case of power outage)
K eep
pu l l ing
Rear cover
Rear cover tabs
R el eas e
N o w ater in th e b ow l
overows.
If the water does not ow due to a power outage
To Next Page
Loading...
Need help?
General