20
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
The appliance
is smoking.
The ingredients have a high oil
content.
Smoking will be normal.
Follow the suggested settings
or food manufacturer’s
recommendations.
The appliance contains grease
from previous use.
White smoke is caused by grease
heating up inside the fryer.
Clean the appliance properly
after each use.
The food is
burned
The food was before pre-
heating was complete.
Add food to the appliance once
pre-heating is completed.
The food was cooked for too
long.
Check on the progress of the
food periodically through the
cooking process.
The food was left in the
appliance after the cooking
time had expired.
Remove the food from the
appliance as soon as the cooking
time has elapsed.
Water is
leaking from
the water tank.
The water tank valve is not
Turn the water tank valve
clockwise to tighten it and secure
it into place.
The water tank is damaged.
Contact the Customer Service
department.
Ingredients
are not cooked
enough
when using
the Steam
function.
There is too much food in the
drawer or the food pieces are
too big.
Put less food into the drawer or
cut the ingredients into smaller
pieces.
The food did not cook for long
enough.
Set a longer cooking cycle, as
detailed in the corresponding
section of this instruction
manual.
The steam generator is dirty.
Use the Steam Clean function
to clean the steam generator, as
detailed in the corresponding
section of this instruction
manual. If required, add in a
cleaning solution made up of
10g citric acid for every 1 litre of
water.
To Next Page
Loading...
