Toyota 8FGCU25 User Manual

1-361-36
REMOVAL·INSTALLATION
Removal Procedure
1 Open the engine hood and disconnect the negative terminal of the battery.
2 Remove the battery.
3 Remove the relay block bracket set bolt and free the relay block.
4 Remove the sedimenter.
5 Remove the battery set plate.
6 Disconnect the injection pump side link.
7 Remove the actuator. [Point 1]
Installation Procedure
The installation procedure is the reverse of the removal procedure.
Note:
• After installation, adjust the throttle opening degree. (Refer to 1-37)
• After installation, operate the accelerator pedal and check that the links are working normally.
LBA26-006
6
7
Engine
Section 1

Toyota 8FGCU25 Specifications

General

Load Capacity	5000 lbs
Lift Height	189 inches
Power Source	Internal Combustion
Fuel Type	Gasoline/LPG
Operator Type	Seated
Lift Speed (loaded/unloaded)	122 fpm
Lowering Speed (loaded/unloaded)	98 fpm / 98 fpm
Mast Height (lowered/raised)	83 inches
Weight	3, 500 kg