7.4. Make a call
You can place a hands-free call using the hands-free system’s voice recognition (VR)
menu in the following ways:
— using the system’s contact list
— digit dial using voice recognition (VR)
— using the handset device’s voice commands
— using Redial
— using the handset device’s memory dial
— dial a number from the handset device.
Pressing the End button terminates the dialing operation.
Make a call using the contact list
Make sure you have entered at least one contact in your Contact List (see chapter 7.5.).
1 Press the Multi-function button.
The system responds: Phone menu. {Say a command}.
2 Say Call <name>.
The system responds: {Call <name> yes or no?}.
3 If the contact recited by the hands-free system is correct, say Yes.
The system responds: Calling <name>.
ó Note: When in Expert Mode, the Call <name> yes or no? prompt is bypassed.
Make a call with voice recognition
You can enter a phone number as one or more segments of digits. A segment can include
up to 15 digits. An entire number can include no more than 32 digits. You can also use +,
*, or # characters when dialing a number. Wait and Pause commands are also accepted.
ó Note: Speak numbers as continuous digits. For example, dictate 555-2211 as
5-5-5-2-2-1-1 (not 5-5-5-twenty-two-eleven).
Call with a whole number
1 Press the Multi-function button.
The system responds: Phone menu. {Say a command}.
2 Say Dial Number.
The system responds: Number please?
3 Say the number as a single set of digits (without pauses between digits).
The hands-free system recites the digits heard.
4 If the number recited by the hands-free system is correct, say Dial (or Yes) to dial the
number.
The system responds: Dialing.
To Next Page
Loading...
