π Transfer private call to hands-free
1 Press the Multi-function button.
The system responds: Call menu. {Say a command}.
2 Say Hands-free Mode.
The system responds: Hands-free mode and transfers the call to the hands-free
system.
ó Note: Pressing and holding the Send button also transfers the call the hands-free
system.
ó Note: Some handset devices disconnect the Bluetooth® link to the system when the
call is switched to privacy mode. In this case, the Call menu will not be available. To
switch the call to hands-free, press and hold the Send button.
Send DTMF tones
1 Press the Multi-Function button.
The system responds: Call menu. {Say a command}.
2 Say Enter <digits> to send digits as DTMF tones.
You can also use * and # characters.
ó Note: You can send DTMF tones from the handset device’s keypad.
π Hold a call
Press the Send button to put an active call on hold.
Press the Send button again to resume a call on hold.
π Call waiting
While in a call, an audible beep signals an incoming call. The Multi-Function button and
mute icon ashes quickly.
Press the Send button to place the active call on hold and answer the waiting call. To
reject a waiting call, press the End button. The Multi-Function button and mute icon stop
ashing when the waiting call is accepted/rejected.
π Switch between active call and held call
1 Press the Multi-function button.
The system responds: Call menu. {Say a command}.
2 Say Switch Call.
The system responds: Switching active calls.
ó Note: Pressing the Send button switches between held and active calls.
To Next Page
Loading...
