116
2-2. Charging
1 Prepare the AC charging cable
(P.110) and the replacement
plug-cord.
2 Pull out the release key.
Make sure that the pulled out release
key is not lost.
3 Remove the plug-cord connec-
tor cap.
4 Insert the release key into the
release slot of the CCID
(Charging Circuit Interrupting
Device).
Insert the release key in the direction
shown in the illustration.
5 With the release key fully
inserted into the release slot of
the CCID (Charging Circuit
Interrupting Device), turn the
plug-cord connector nut of the
plug-cord to remove the cord.
After the plug-cord is removed, remove
the release key.
Do not leave the vehicle alone with the
plug-cord removed. If the plug-cord is
not installed, water or other foreign
matter may enter the CCID (Charging
Circuit Interrupting Device), resulting in
a malfunction.
6 Align the protrusion of the CCID
(Charging Circuit Interrupting
Device), with the groove of the
plug-cord, insert the plug-cord
into the CCID (Charging Circuit
Interrupting Device), and then
turn the plug-cord connector nut
of the plug-cord to install it.
To Next Page
Loading...
