224
3-1. Instrument cluster
• Driving support system information
display
• Compass (if equipped)
• Audio system operation status
Display angle
Select to adjust the angle of the head-
up display.
■ Enabling/disabling of the head-up
display
If the head-up display is disabled, it will
remain disabled when the power switch
is turned off then back to ON.
■ Display brightness
The brightness of the head-up display
can be adjusted on screen of the
multi-information display. Also, it is auto-
matically adjusted according to the
ambient brightness.
■ Driving support system infor-
mation display
Displays the operational status of
the following systems:
LTA (Lane Tracing Assist) (if
equipped) (P.353)
Dynamic radar cruise control
with full-speed range (if
equipped) (P.368)
Displayed content is the same as that
displayed on the meter. For details,
refer to the explanations of each sys-
tem.
■ Navigation system-linked dis-
play area (if equipped)
Displays the following items which
are linked to the navigation system:
Street name
Route guidance to destination
Compass
Pop-up displays for the following
systems will be displayed when
necessary:
■ Driving support systems
Displays a warning/sugges-
tion/advice message or the operat-
ing state of a relevant system.
PCS (Pre-Collision System) (if
equipped) (P.343)
■ Caution for changing settings of
the head-up display
If the hybrid system is operating when
changing the display settings, ensure
that the vehicle is parked in a place
with adequate ventilation. In a closed
area such as a garage, exhaust
gases including harmful carbon mon-
oxide (CO) may collect and enter the
vehicle. This may lead to death or a
serious health hazard.
■ When changing the settings of
the head-up display
To prevent 12-volt battery discharge,
ensure that the hybrid system is oper-
ating while changing the settings of
the head-up display.
Driving support system
information/navigation sys-
tem-linked display area (if
equipped)
Pop-up display
To Next Page
Loading...
