457
6
6-4. Using the other interior features
Interior features
charge area, charging will automati-
cally stop.
If 2 or more portable devices are
placed on the charging tray, their
charging coils may not be properly
detected and they may not be
charged.
■ Using the wireless charger
1 Press the power supply switch
of the wireless charger.
Switches on and off with each press of
the power supply switch.
When turned on, the operation indicator
light (green) comes on.
Even with the hybrid system off, the
on/off state of the power supply switch
is memorized.
2 Place the portable device on the
charging tray
Place the charging side of the portable
device down with the center of the
device in the center of the charge area.
Depending on the portable device, its
charging coil may not be in the center
of the device. In this case, place the
portable device so that its charging coil
is centered in the charging area.
When charging, the operation indicator
light (orange) comes on.
If charging is not occurring, try placing
the portable device as close to the cen-
ter of the charging area as possible. If
charging is not performed, the opera-
tion indicator light will slowly illuminate
in green and orange alternatively and a
sound of charging coil operation may
be heard repeatedly.
When charging is complete, the opera-
tion indicator light (green) comes on.
■ Recharging function
When charging is complete and
after a fixed time in the charge
suspension state, charging
restarts.
If a portable device is moved sig-
nificantly within the charging
area, the charging coil may dis-
connect and charging may tem-
porarily be stopped. However, if
a charging coil is detected within
the charging area, the charging
coil inside the wireless charger
will move near the other coil and
charging will resume.
■ Rapid charging function
The following portable devices
support rapid charging.
• Portable devices compliant with WPC
Ver1.2.4 and compatible with rapid
charging
• iPhone’s with an iOS version that
supports 7.5 W charging (iPhone 8
and later models)
To switch to the rapid charging
function, press the power supply
switch 3 times while charging.
To Next Page
Loading...
