TP-Link Archer AC2600 - Customize Your Network Settings; Change the LAN Settings; Set Up Link Aggregation; Configure to Support IPTV Service

10
Chapter 2
Connect the Hardware
6. Confirm that the following LEDs are on and solid to verify the hardware is connected
correctly.
Power
On
On
Internet
5GHz
On
2.4GHz
On
Note:
• If all the LEDs are off, press the LED On/Off button at the top panel for about 1 second, and then check the LEDs again.
• If the 2.4GHz and 5GHz LEDs are off, press the Wi-Fi On/Off button at the side panel for about 2 seconds, then both
LEDs should turn stable in a few seconds.
Tip:
For optimum performance, orient the four antennas as shown in the drawing below.
30° 30°
7. Connect your computer to the router.
• Method 1: Wired
Turn off the Wi-Fi on your computer and connect the devices as shown below.
Ethernet Cable
• Method 2: Wirelessly
1 ) Find the SSID (Network Name) and Wireless Password printed on the label at
the bottom of the router.
2 ) Click the network icon of your computer or go to Wi-Fi Settings of your smart
device, and then select the SSID to join the network.
C
onnections are availabl
e
Wireless Network
C
onnection
Connect automatically
Connect
TP-Link_XXXX
TP-Link_XXXX_5G
Wi-Fi
Wi-Fi
TP-Link_XXXX
TP-Link_XXXX_5G
CHOOSE A NETWORK...
Other...
< Settings
OR
Smart DeviceComputer