19
Chapter 4
Set Up Internet Connection
Note:
It may take 1-2 minutes to make the settings valid.
Tips:
• If your internet connection type is BigPond Cable, please go to Advanced > Network > Internet to set your router.
• If you use Dynamic IP and PPPoE and you are provided with any other parameters that are not required on the page,
please go to Advanced > Network > Internet to complete the configuration.
• If you still cannot access the internet, refer to the FAQ section for further instructions.
4. 3. Set Up the Router as an Access Point
If you have another router, you can switch this new router to Access Point mode to
extend your existing network.
1. Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for
the r
outer.
2. Go to Advanced > Operation Mode, select Access Point and click Save. The router
will r
eboot and switch to Access Point mode.
To Next Page
Loading...
