21
Chapter 4
Set Up Internet Connection
Tips:
• Functions, such as Parental Controls, QoS and NAT Forwarding, are not supported in the Access Point mode.
• Functions, such as Guest Network and USB Settings, are similar with those in the Router mode.
4. 4. Set Up an IPv6 Internet Connection
You can set up an IPv6 internet connection if your ISP provides information about one
of the following IPv6 internet connection types: PPPoE, Dynamic IP(SLAAC/DHCPv6),
Static IP, 6to4 tunnel, Pass-Through (Bridge).
1. Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for
the r
outer.
2. Go to Advanced > IPv6.
3.
Enable IPv6 and select the internet connection type provided by your ISP.
Tips:
If you do not know what your internet connection type is, contact your ISP or judge according to the already known
information provided by your ISP.
4. Fill in information as required by different connection types. Red blanks must be filled
in.
1 ) Static IP: Fill in blanks and click Save.
To Next Page
Loading...
