71
Chapter 12
Customize Your Network Settings
• LACP active: enables LACP (Link Aggregation Control Protocol) unconditionally.
• LACP passive: enables LACP only when an LACP device is detected.
5. Specify two ports for link aggregation.
6. Click Save.
12. 3. Configure to Support IPTV Service
Configure IPTV setup to enable Internet/IPTV/Phone service
provided by my internet service provider (ISP).
1. Visit http://tplinkwifi.net, and log in with your TP-Link ID or
the passw
ord you set for the router.
2. Go to Advanced > Network > IPTV/VLAN.
3.
If your ISP provides the networking service based on IGMP
technology, for example, British Telecom(BT) and Talk Talk in
UK:
1 ) Check the box for IGMP Proxy and select the IGMP
V
ersion, either V2 or V3, as required by your ISP.
2 ) Click Save.
3 ) After configuring IGMP proxy, IPTV can work behind your
router now. You can connect your set-top box to any of
the router’s Ethernet port.
If IGMP is not the technology your ISP applies to provide
IPTV service:
I want to:
How can
I do that?
To Next Page
Loading...
