51
Chapter 11
Note:
Before you enable VPN Server, we recommend you configure Dynamic DNS Service (recommended) or assign a static
IP address for router’s WAN port and synchronize your System Time with internet.
3. In the Client IP Address filed, enter the range of IP addresses (up to 10) that can be
leased to the devices by the PPTP VPN server.
4. Select Allow Samba (Network Place) access to allow your VPN client to access your
Samba server.
5. Select Allow NetBIOS passthrough to allow your VPN client to access your Samba
server using NetBIOS name.
6. Select Allow Unencrypted connections to allow unencrypted connections to access
your VPN server.
¾ Step 2. Configure PPTP VPN Connection on Your Remote Device
The remote device can use the Windows built-in PPTP software or a third-party PPTP
software to connect to PPTP Server. Here we use the Windows built-in PPTP software
as an example.
1. Go to Start > Control Panel > Network and Internet > Network and Sharing Center.
2. Select Set up a new connection or network.
To Next Page
Loading...
