TP-Link CPE Series - Set Up the Wireless Network; Access Point

Quick Start Guide (CPE and WBS) Set Up the Wireless Network
Configuration Guide
5
3
Set Up the Wireless Network
You can use the Quick Setup wizard to quickly configure your device step by step. Choose
the suitable operation mode according to your network environment and follow the step-
by-step instructions.
3.1 Access Point
Follow the steps below to configure the device as Access Point mode:
1) Go to the QUICK SETUP page, select
Access Point and click Next .
Figure 3-1 Selecting an Operation Mode
2) In the LAN Settings section, specify the LAN IP address and the Subnet Mask for the
device. Then, click
Next .