6
4. Use the new username and password to log in.
Tips:
The EAP is preset with a default IP 192.168.0.254, which you can use to log in to its web
management page. Follow the steps below:
1. Connect the EAP to your computer with an Ethernet Cable.
2. Assign a static IP address 192.168.0.X (X ranges between 2 and 253) together with
the subnet mask 255.255.255.0 to your computer.
3. Open a web browser and enter 192.168.0.254 in the address bar to load the login
page of the EAP.
4. Refer to
Step3: Configuring the EAP Device
to configure the SSID and password. You
can surf the internet after connecting your EAP to a LAN port of the router.
Step3: Configuring the EAP Device
After logging in to the EAP, we recommend that you change the SSID configuration
immediately for secure management purpose.
To Next Page
Loading...
