Need help?Do you have a question about the TP-Link EAP110 and is the answer not in the manual?
General| 2.4 GHz | Yes |
|---|---|
| Frequency band | 2.4 - 2.4835 GHz |
| Networking standards | IEEE 802.11b, IEEE 802.11g, IEEE 802.11n |
| Receiver sensitivity | 300M: -71dBm@10% PER 150M: -75dBm@10% PER 54M: -78dBm@10% PER 11M: -93dBm@8% PER 6M: -92dBm@10% PER 1M: -96dBm@8% PER |
| Ethernet LAN data rates | 10, 100 Mbit/s |
| Maximum data transfer rate | 300 Mbit/s |
| Internal | No |
| Certification | CE, FCC, RoHS |
| Product color | White |
| Cable lock slot type | Kensington |
| WAN connection | Ethernet (RJ-45) |
| Ethernet LAN (RJ-45) ports | 1 |
| Security algorithms | 64-bit WEP, 128-bit WEP, 152-bit WEP, WPA, WPA-PSK, WPA2, WPA2-PSK |
| Storage temperature (T-T) | -40 - 70 °C |
| Operating temperature (T-T) | 0 - 40 °C |
| Storage relative humidity (H-H) | 5 - 90 % |
| Operating relative humidity (H-H) | 10 - 90 % |
| Compatible operating systems | Microsoft Windows 8, 7, Vista, XP |
| Input current | 1 A |
| AC input voltage | 24 V |
| Power consumption (typical) | 7.7 W |
| Antenna features | Integrated antenna |
| Antennas quantity | 2 |
| Antenna direction type | Omni-directional |
| Antenna gain level (max) | 3 dBi |
Weight and Dimensions| Width | 180 mm |
|---|---|
| Height | 47.5 mm |
Guides users on choosing between EAP Controller and web page management for network setup.
Details how to change the default wireless network name (SSID) for security.
Overview of post-setup configuration and management tabs for network, wireless, etc.
Explains setting dynamic or static IP addresses for the EAP device.
Guides through configuring basic wireless settings, SSIDs, and advanced parameters.
Details setting up captive portal for guest authentication and customization.
Displays AP list with device name, MAC address, and total connected clients.
Covers viewing system logs, configuring log receiving methods, and backing up logs.
Controls access to the EAP management page via MAC authentication.
Details changing the default admin username and password for EAP access security.
Provides instructions for rebooting and restoring the EAP to factory defaults.
Steps to access the EAP's web interface using its IP address.
To Next Page
