TP-Link GPON OLT P1200-08 - Configuring service on HGU (Gateway ONT); Configuring the Internet Access Service

12
OLT(interface-gpon)# ont port car 4 1 eth 1 inbound 123 outbound 123
6. Save the data
OLT(config)# save
 The ONT does not need to be configured.
----End
5.6 Configuring service on HGU (Gateway ONT)
This topic describes how to configure Internet access service, voice service, BTV service and VoD
service when HGU is used to build an FTTH network.
The ONT integrating an IAD provides Internet, VoIP, and IPTV services to users. The HGU
facilitates interconnection of home devices by providing Layer 3 services, such as Point-to-Point
Protocol over Ethernet (PPPoE)/DHCP dial-up, network address translation (NAT), and Internet
Group Management Protocol (IGMP) snooping. This scenario provides fine-grained management
channels and service control, and mainly applies to Layer 3 networking.
4.6.1 Configuring the Internet Access Service
Prerequisites
 The OLT is connected to the uplink device successfully
 The ONT has been added to the OLT. For details, see chapter 4.3
 The VLAN of the LAN switch port connected to the OLT uplink port is the same as the uplink
VLAN of the OLT
Data Plan
Item
Data
ONT Line Profile
Line Profile: 10
T-CONT ID: 1
Internet Access Service GEM Port ID: 11
Network topology and VLAN Plan
Uplink Port: GE9 VLAN: 100
PON Port: PON4 VLAN: 100
ONT2 WAN: veip0.2 VLAN: 100
Configuring Process
 Configure OLT：
1、Configure the mapping between a GEM port and a VLAN.
The service flow of C-VLAN 100 is mapped to GEM port 11 in the ONT line profile.
OLT(config)# ont-lineprofile profile-id 10
OLT(ont-lineprofile-10)# gem mapping 11 1 vlan-id 100
OLT(ont-lineprofile-10)# commit
OLT(ont-lineprofile-10)# exit
2、Create an Internet access service VLAN and add an uplink port to it.
Add uplink port GE9 to VLAN 100.
OLT(config)# vlan 100