TD-8816 ADSL2+ Modem Router User Guide
49
Figure 4-39
SNMP: Activate or deactivate the function.
Get Community: Select to set the password for the incoming Get requests from the
management station.
Set Community: Select to set the password for incoming Set requests from the
management station.
Trap Host: Enter the trap host here.
4.5.4 UPnP
Choose “Access Management→UPnP”, you can configure the UPnP in the screen (shown in
Figure 4-40).
UPnP (Unive
rsal Plug and Play) is a distributed, open networking standard that uses TCP/IP for
simple peer-to-peer network connectivity between devices. An UPnP device can dynamically join
a network, obtain an IP address, convey its capabilities and learn about other devices on the
network. In turn, a device can leave a network smoothly and automatically when it is no longer in
use. UPnP broadcasts are only allowed on the LAN.
Figure 4-40
UPnP: Activate or deactivate the UPnP function. Only when the function is activated can the
UPnP take effect.
Auto-configured: If you activate the function, then the UPnP network devices can
automatically configure network addressing, announce their presence in the network to other
UPnP devices and enable exchange of simple product and service descriptions.
To Next Page
Loading...
