TP-Link TD-W8901N - Quick Installation Guide Manual

Quick Installation Guide
TD-W8901N
150Mbps Wireless N ADSL2+ Modem Router
Connecting the Hardware
If you don’t need the phone service, just skip step 1 and directly
connect the modem router to the phone jack with a phone cable,
then follow steps 3 and 4 to complete the hardware connection.
POWER ON/OFF
WiFi
WPS/
RESET
LAN4
LAN1
LAN3
LAN2
ADSL
ADSL Splitter
Phone Jack
Power Adapter
Modem Router
3 Turn on the modem router.
Connect the ADSL splitter to
the phone jack.
PHONE MODEM
LINE
1
Connect the modem
router to the ADSL splitter.
2
Connect to the phone (Optional)
Wireless
Power
On
Notes:
1. The ADSL LED takes about 1 to 2 minutes to
stabilize.
ADSL
On On
4
Verify that the hardware connection
is correct by checking these LEDs.
2. If the Wireless LED is o, please press the WiFi
button on the rear panel, then the LED should turn
stable in a few seconds.