2
Plug the provided Power
Adapter into the Power jack
on the back of the Modem
Router and the other end to a
standard electrical wall
socket.
Turn on all of your network devices, including your computer(s) and
the
Modem Router then check to see if the LEDs of the Modem Router display
normally as the diagram below describes.
If the LEDs display abnormally, please check to see if all the cable
connectors (power adapter, phone line and Ethernet cable) are well
connected to your device. With the phone line well connected, if the
ADSL LED turns off after a quick-flash, please contact your ISP to ensure
that your internet connection is active.
Note
Power: Solid light
ADSL: Flashing
or solid li
To Next Page
Loading...
