1
Power down all your network devices, including your computer(s) and the
Modem Router. If you currently use a modem, disconnect it now - the
Modem Router will replace your current modem.
Connect your computer to the
Port labeled “1~4” on the Router
with an Ethernet cable.
Connect the splitter to the wall
jack using a telephone line, then
use the other telephone line to
connect to the LINE port on the
Router and the MODEM port of
the splitter, also have the PHONE
port of the splitter connected to a
telephone.
If no telephone is needed, please connect the LINE port of the Router to
the wall jack using the telephone line directly.
Note
Note
Please use only wired network connections to configure the router.
Installation
Note
The product model shown in this QIG is TD-W8951ND, as an example.
To Next Page
