Connecting the Hardware
If you don’t need the phone service, just skip step 1 and
directly connect the modem router to the phone jack with a
phone cable, then follow steps 3 and 4 to complete the
hardware connection.
300Mbps Wireless N USB ADSL2+ Modem Router
TD-W8968
Wi-Fi
On
Power
On
ADSL
On
Verify that the hardware connection is
correct by checking these LEDs.
Notes:
1) The ADSL LED takes about 1 to 2 minutes to
stabilize.
2) If the Wi-Fi LED is off, please press the WiFi
button on the rear panel for 2 seconds, then the
LED should turn stable in a few seconds.
Power Adapter
ADSL Splitter
Phone Jack
Modem Router
Connect the modem router to
the ADSL splitter.
Connect the ADSL splitter to the
phone jack.
1
2
Connect the power adapter to the
modem router and push in to turn
on the modem router.
3
4
To Next Page
