TP-Link TL-PA9020P - Set up a New Powerline Network - Plug and Play

7
Chapter 2 Use the Powerline Adapter
2. 2. Set Up a New Powerline Network - Plug and Play
Use two powerline adapters to set up a new powerline network
in my house.
For example, I have a router in my house, but there are not
enough LAN ports to support all my wired devices. I don’t want
complex and expensive dedicated cabling. So I bought two
powerline adapters to extend the network via my household
electrical wiring.
1. Connect one of the powerline adapters to an available LAN
port of the router using an Ethernet cable.
2. Plug the powerline adapter into a wall socket.
3. Plug the second powerline adapter into a wall socket where
you want to add Internet access. Wait until the powerline
LED turns on.
. Note: If the Powerilne LED does not turn on, reset each powerline adapter to
its factory default settings. You can refer to How do I reset my powerline adapter?.
Then redo steps 1 to 3.
4. Connect your wired device, such as computer or game
console, to the powerline adapter using an Ethernet cable.
Powerline
Powerline Adapter
Powerline Adapter
Router
WAN LAN
1
2
3
4
Now enjoy the Internet!
I want to:
How can I
do that?
Done!