55
Web Smart Gigabit Switch Family User's Guide
TL-SG2109WEB/TL-SL2210WEB/TL-SL2218WEB/TL-SL2428WEB/TL-SL2452WEB
All Ports: By operating on this eld expediently, you can set the values of
all ports in the corresponding eld.
All VLAN: Display all dened Tag VLANs.
Figure 5-40 All Tag VLAN
Select All: Select all ports to be the VLAN member.
Clean Up: Clean up all members of the VLAN.
Submit: Submit to buildup a VLAN with the selected members.
Notice:
1) VID of the VLAN must be unique and within the range of 1 to 4094.
2) At least two port members should be included to add a VLAN group. (If the
page is submitted with 0 VLAN member, it indicates to delete the VLAN.)
3) If any Trunk has been set, the Trunk can be configured as a VLAN
member and member ports of the Trunk cannot be congured (see Port 1
and 2 in the gure for example).
4) If the port is connected to a device that doesn’t support IEEE802.1Q (e.g.
HUB and some network adapter), value of the Egress Frame eld should
be set to “Drop Tag”.
5) For the first time the Port VLAN mode is set, a default VLAN, which is
indexed as NO. 1 and contains all switch ports, will be built up.
6) The ports haven’t been assigned to any VLAN manually cannot
communicate with each other or other VLAN. That’s different from the Port
VLAN.
To Next Page
Loading...
