Configuration Procedure
n h A
Co figure Switc
S tep Operation Description
1
ype of the rt 13 as ACCESS, and configure the link type
Configure the
Link T
ports
Required. On VLAN→802.1Q VLAN→Port Config page, configure the
link type of Port 11 and Po
of Port 12 as GENERAL.
2 Create VLAN10
12 and Port 13, and
Required. On VLAN→802.1Q VLAN→VLAN Config page, create a
VLAN with its VLAN ID as 10, owning Port
configure the egress rule of Port 12 as Untag.
3 Create VLAN20
11 and Port 12, and
configure the egress rule of Port 12 as Untag.
Required. On VLAN→802.1Q VLAN→VLAN Config page, create a
VLAN with its VLAN ID as 20, owning Port
Con h B figure Switc
S tep Operation Description
1
ype of the ort 5 as ACCESS, and configure the link type of
Configure the
Link T
ports
Required. On VLAN→802.1Q VLAN→Port Config page, configure the
link type of Port 4 and P
Port 3 as GENERAL.
2 Create VLAN10
g Port 3 and Port 4, and configure
Required. On VLAN→802.1Q VLAN→VLAN Config page, create a
VLAN with its VLAN ID as 10, ownin
the egress rule of Port 3 as Untag.
3 Create VLAN20
g Port 3 and Port 5, and configure
Required. On VLAN→802.1Q VLAN→VLAN Config page, create a
VLAN with its VLAN ID as 20, ownin
the egress rule of Port 3 as Untag.
4 Create rotocol
Tem p lat e
P Required. On VLAN→Protocol VLAN→Protocol Template page,
configure the protocol template practically. E.g. the Ether Type of IP
network packets is 0800 and that of AppleTalk network packets is 809B.
5 Port Enable Required. On the VLAN→Protocol VLAN→Port Enable page, select
and enable Port 3, Port 4 and Port 5 for Protocol VLAN feature.
6 Create rotocol Protocol VLAN page, create protocol P
VLAN 10
On VLAN→Protocol VLAN→
VLAN 10 with Protocol as IP.
7 Create rotocol
VLAN 20
ol VLAN page, create protocol
VLAN 20 with Protocol as AppleTalk.
P On VLAN→Protocol VLAN→Protoc
Return to CONTENTS
70
To Next Page
Loading...
