13
Chapter 2
Set Up Internet Connection
SSID 1 for VLAN 1
SSID 2 for VLAN 2
SSID 3 for VLAN 3
SSID 4 for VLAN 4
VLAN 1
VLAN 2
VLAN 3
VLAN 4
Internet
Existing Router
Access Point
A
B
C
D
1. Connect the access point according to Step A to D in the diagram.
2. Turn on the power, and wait for about 2 minutes until the Power and Wi-Fi LEDs are lit
and stable.
3. Use the default SSID and Password printed on the label of the access point to join its
Wi-Fi network.
4. Launch a web browser and enter http://tplinkap.net. Create a password to log in.
Note:
If the login window does not appear, please refer to the FAQ section.
5. Click Change Mode in the upper right corner and switch to the Multi-SSID mode.
6. Wait until the access point reboots, then reconnect to the access point and log in
again.
7. Follow the step-by-step instructions to complete the configuration.
8. Now, connect your wireless devices to the Wi-Fi networks and enjoy the internet!
Tip:
If you want to isolate different networks, go to Wireless > Wireless Settings, click the edit icon of each SSID entry and
set different VLAN IDs.
To Next Page
Loading...
