28
Chapter 4
Wireless Settings
2 ) Enter your client’s PIN, and then click CONNECT.
3 ) A success message will appear on the WPS page when the device successfully
join the access point’s network.
• Connect via the access point’s PIN
1 ) Click Access Point’s PIN.
2 ) Check your access point’s PIN. You can use the default PIN or generate a new
one.
3 ) Enter this PIN on your client for it to join the access point’s network.
• Connect via the Start button on the WPS page
1 ) Click the Start button on the WPS page.
2 ) Within 2 minutes, enable WPS on your client.
3 ) A success message will appear on the WPS page when the device successfully
join the access point’s network.
• Connect via the WPS button on the access point
To Next Page
Loading...
