10
T1. How do I restore my Access Point’s configuration to its factory default settings?
T2. What can I do if I forget my password?
1) Restore the Access Point’s configuration to its factory default settings. If you
don’t know how to do that, please refer to previous section T1;
2) Use the default user name and password: admin, admin;
3) Try to reconfigure your AP by following the instructions of this QIG.
T3. What can I do if I cannot access the web-based configuration page?
Assign a static IP address 192.168.0.100 for your computer first before logging in the
management page. Here takes the procedures in Windows 7 for example.
With the Access Point powered on,
use a pin to press and hold the
RESET button on the rear panel fo
8 to 10 seconds before releasing it.
Once the Access Point is reset, the current configuration settings will be lost
and you will need to reconfigure the Access Point.
Note
Go to Start > Settings > Control
Panel, and then you will see the
following page.
Click View network
status and tasks
Hold it in for 8 to 10 seconds
To Next Page
Loading...
