117
Chapter 5
Configure the Router in WISP Mode (Hotspot Mode)
Download and install the certificate for management via HTTPS if you need it. Once the
certificate is installed, warnings will not pop up when you access the router via HTTPS.
5. 16. 9. Remote Management
This feature allows you to manage your router from a remote location via the internet.
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to System Tools > Administrator, and focus on the Service Configuration section.
• Forbid all devices to manage the router remotely
Do not tick the Enable checkbox in both HTTP Service and HTTPS Service.
• Allow all devices to manage the router remotely
1. Tick the Enable checkbox in HTTP Service.
2. If you want to access the router via both HTTPS and HTTP, please tick the Enable
checkbox in HTTPS Service column. Otherwise, keep it disbled.
3. For higher security, you can change the remote management web port by entering a
number between 1024 and 65534.
4. Click Save.
• Allow a specific device to manage the router remotely
1. Tick the Enable checkbox in HTTP Service.
2. If you want to access the router via both HTTPS and HTTP, please tick the Enable
checkbox in HTTPS Service column. Otherwise, keep it disbled.
3. For higher security, you can change the remote management web port by entering a
number between 1024 and 65534.
4. Enter the IP or MAC address of the host that you want to manage the router in the
Available Host (IP/MAC) entry. The format of the MAC address is XX:XX:XX:XX:XX:XX
(X is any hexadecimal digit).
5. Click Save.
• Certificate
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
