99
Chapter 5
Configure the Router in WISP Mode (Hotspot Mode)
Done!
Now only the specific host(s) can visit the target(s) within the scheduled time period.
Note:
When LAN Host and Target are both set to be the MAC Address mode, you need to set Protocol: ALL, TCP,
UDP, ICMP. The default setting is ALL and it is recommended to keep the default setting.
5. 11. Advanced Routing
Static Routing is a form of routing that is configured manually by a network administrator
or a user by adding entries into a routing table. The manually-configured routing
information guides the router in forwarding data packets to the specific destination.
5. 11. 1. Static Route List
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to Advanced Routing > Static Route List.
• To add static routing entries:
1. Click Add New.
2. Enter the following information.
• Destination IP Address - The Destination Network is the address of the network
or host that you want to assign to a static route.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
