44
Chapter 4
Configure the Router in Wireless Router Mode
6. Select Enable Internet Access Control to enable Access Control function.
7. Select Allow the packets specified by any enabled access control policy to pass
through the Router as the default filter policy and click Save.
Done!
Now only the specific host(s) can visit the target(s) within the scheduled time period.
Note:
When LAN Host and Target are both set to be the MAC Address mode, you need to set Protocol: ALL, TCP,
UDP, ICMP. The default setting is ALL and it is recommended to keep the default setting.
4. 11. Advanced Routing
Static Routing is a form of routing that is configured manually by a network administrator
or a user by adding entries into a routing table. The manually-configured routing
information guides the router in forwarding data packets to the specific destination.
4. 11. 1. Static Route List
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to Advanced Routing > Static Route List.
• To add static routing entries:
1. Click Add New.
2. Enter the following information.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
