98
Chapter 5
Configure the Router in WISP Mode (Hotspot Mode)
3 ) Click Save.
5. Go to Access Control > Rule and add a new access control rule.
1 ) Click Add New.
2 ) Give a name for the rule in the Description field. Select host_1 from the LAN host
drop-down list; select target_1 from the target drop-down list; select schedule_1
from the schedule drop-down list.
3 ) Leave the status as Enabled as click Save.
Note:
When Target is set to be URL Address mode, the Direction field is OUT and not editable, which means
the host can only visit or is not allowed to visit the URL address you set.
6. Select Enable Internet Access Control to enable Access Control function.
7. Select Allow the packets specified by any enabled access control policy to pass
through the Router as the default filter policy and click Save.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
