142
Chapter 6
Congure the Router in Access Point Mode
• Allow all LAN conencted devices to manage the router locally
1. Keep the Available Host (IP/MAC) empty, which means you don’t specify any host to
manage the router.
2. If you want to access the router via both HTTPS and HTTP, please tick the Enable
checkbox in HTTPS Service column. Otherwise, keep it disbled.
3. Keep the local management port as default if you don’t know which port to use.
4. Click Save.
Note:
If the web management port conflicts with the one used for Virtual Server entry, the entry will be automatically disabled
after the setting is saved.
• Allow a specific device to manage the router locally
1. Enter the IP or MAC address of the host that you want to manage the router in the
Available Host (IP/MAC) entry. The format of the MAC address is XX:XX:XX:XX:XX:XX
(X is any hexadecimal digit).
2. If you want to access the router via both HTTPS and HTTP, please tick the Enable box
in HTTPS Service column. Otherwise, keep it disbled.
3. Keep the Port as default if you don’t know which port to use.
4. Click Save.
Note:
If your PC is blocked but you want to access the router again, press and hold the Reset button to reset the router to the
factory defaults.
• Certificate
Download and install the certificate for management via HTTPS if you need it. Once the
certificate is installed, warnings will not pop up when you access the router via HTTPS.
6. 7. 10. System Log
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to System Tools > System Log, and you can view the logs of the router.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
