158
Chapter 7
Configure the Router in Range Extender Mode
7. 6. 6. Account Management
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to System Tools > Administrator, and focus on the Account Management section.
You can change the factory default username and password of the router.
It is strongly recommended that you change the default username and password of the
router, for all users that try to access the router’s web-based utility or Quick Setup will
be prompted for the router’s username and password.
Note:
The new username and password must not exceed 15 characters and not include any spacing.
3. Click Save.
7. 6. 7. Local Management
This feature allows you to block computers on the LAN from accessing the router by
using the MAC/IP-based authentication.
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to System Tools > Administrator, and focus on the Service Configuration section.
• Allow all LAN conencted devices to manage the router locally
1. Keep the Available Host (IP/MAC) empty, which means you don’t specify any host to
manage the router.
2. If you want to access the router via both HTTPS and HTTP, please tick the Enable
checkbox in HTTPS Service column. Otherwise, keep it disbled.
3. Keep the local management port as default if you don’t know which port to use.
4. Click Save.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
