167
Chapter 6
Configure the Router in Access Point Mode
1. Visit http://tplinkwifi.net, and log in with the username and
password you set for the router.
2. Go to Setting > Wireless 2.4GHz > Wireless MAC Filtering.
3. Click Enable to enable the Wireless MAC Filtering function.
4. Select Allow the stations specified by any enabled entries in
the list to access as the filtering rule.
5. Delete all or disable all entries if there are any entries already.
6. Click Add New and fill in the blank.
1 ) Enter the MAC address 00-0A-EB-B0-00-0B/00-0A-EB-00-
07-5F in the MAC Address field.
2 ) Enter wireless client A/B in the Description field.
3 ) Select Enabled in the Status drop-down list.
4 ) Click Save and click Back.
7. The configured filtering rules should be listed as the picture
shows below.
Now only client A and client B can access your network.
6. 4. 5. Wireless Advanced
1. Visit http://tplinkwifi.net, and log in with the username and password you set for
the router.
2. Go to Setting > Wireless 2.4GHz > Wireless Advanced.
3. Configure the advanced settings of your wireless network and click Save.
How can I
do that?
Done!
To Next Page
Loading...
