TP-Link TP-TL-WR1043N - Page 76

73
Chapter 4 Configure the Router in Standard Router Mode
• Line Type - Select the right type for you network connection. If you are not sure,
please consult your ISP.
• Egress Bandwidth - The upload speed through the WAN port.
• Ingress Bandwidth - The download speed through the WAN port.
4. 11. 2. Rules List
1. Visit http://tplinkwifi.net, and log in with the username and password you set for
the router.
2. Go to Advanced > Bandwidth Control > Rules List, and you can view and configure
the Bandwidth Control rules.
• Description - This is the information about the rules such as address range.
• Egress Bandwidth - This field displays the max and min upload bandwidth through
the WAN port. The default is 0.
• Ingress Bandwidth - This field displays the max and min download bandwidth through
the WAN port. The default is 0.
• Enable - This field displays the status of the rule.
• Modify - Click Modify/Delete to edit/delete the rule.
¾ To add a Bandwidth control rule:
1. Click Add New.
2. Enter the information like the figure shown below.