115
Note:
CPE610 doesn’t support this feature.
Go to the 0DQDJHPHQW page. In the 566,/('7KUHVKROGV section, configure the
following parameters and click
Apply
.
LED1/LED2/
LED3/LED4
Displays the LED number.
Thresholds Specify the threshold for the desired LED. The specified LED will light up
if the signal strength reaches the values in the field. The default values
are set according to the verified optimum values. We recommend you
keep it by default.
The default LED threshold values may vary among different product
models in terms of radio features.
Click
Apply
, then click
Save
.
To Next Page
Loading...
