TP-Link WBS210 - Page 31

27
$35RXWHU
Follow the steps below to configure the device as AP Router Mode:
Go to the 48,&.6(783 page, select
AP Router and click Next .
Note:
The following window will pop up. Click Yes.
• For CPE210/CPE510/CPE610
Note that if you select AP Router as the operation mode, the status of Port0 will change to WAN,
and the management access will be disabled on this port after the process of quick setup. If you
want to manage the device through Port0, configure the Remote Login IP Address. For details,
refer to
6.5. Configure Web Server .