TP-Link WBS210 - Page 54

50
ARP is used to associate each IP address to the unique hardware MAC address of each
device on the network.
IP Address Displays the IP address of the corresponding ARP entry.
MAC Displays the MAC address of the corresponding ARP entry.
Interface Displays the interface connected to the device.
Auto Refresh Enable or disable Auto Refresh. With this feature enabled, the table will
refresh automatically.
3.11 0RQLWRU5RXWHV
Go to the STATUS page. In the 0RQLWRU section, select Routes and monitor the routing
entries recorded by the device in the Routing table. Routing table is used for the device to
decide the interface to forward the packets. You can enable or disable
Auto Refresh . With
this feature enabled, the table will refresh automatically.
• IPv4 Routes
Destination Displays the IP address of the destination device or destination network.
Gateway Displays the IP address of the appropriate gateway.
SubnetMask Displays the Subnet Mask of the destination network.