The streaming client can
not connect to a network.
On the display the
indication
'SCL Connecting...'
is displayed.
Cause 1 (cable LAN):
Network cable not properly connected
Remedy:
Connect network cable, check connection to router
Cause 2 (radio network):
USB-WLAN stick not connected, or connected while the device was already
switched on.
Remedy:
Switch the machine off, and connect the USB-WLAN stick supplied in the set.
Now switch the machine on, and enter the network parameters (see the section
entitled ‘Network configuration’).
Cause 3 (wireless LAN):
WLAN reception qualiy bad (low field strength). Possibly too much attenuated
by walls/ceilings on the transmission path.
Remedy:
Optimize location of receiver and transmitter antennas.
Alternative:
If transmission problems persist a so called ‚Power Line‘ network might be good
alternative to establish a good and stable network connection.
The best, safest and most secure network however will always be a cable LAN
network.
Cause 4:
Netzwork parameters not properly configured.
Remedy:
Configure the network parameters correctly (see chapter 'Network
configuration').
Transmission interruptions
occur when listening to
internet radio stations.
Cause 1:
The capacity of the internet radio station‘s server is at it‘s limit.
Remedy:
Choose a different station.
Cause 2:
Network problems occurred.
Remedy:
Check your network (see above).
Some internet radio stations
can not be received
Cause:
The internet radio station has been switched off, it transmits only at certain
hours of the day or it has changed ist internet address.
Remedy:
Try to get information from the website of the station regarding transmission
hours ans internet address (URL).
Try to establish a connection to the station at a later time.
Bad sound quality bei
certain internet radio
stations
Cause:
The station transmits with a low audio bandwidth (low bitrate).
Remedy:
Use stations transmitting at least at 128 kBit/s. This is the lowes recommended
bitrate for adequate sound quality. For good sound quality we recommend high
bitrates like 320 kBit/s
USB Storage device is not
recognised
Cause 1:
The storage device (especially USB hard discs without separate power supply)
draws more electrical current from the USB interface than is permitted by the
USB standard.
Remedy:
Only use USB storage devices that conform to the USB standard or use storage
devices with own power supplies.
To Next Page
Loading...