Software updates keep your R 1000 E up-to-date. They bring new optimisations
like faster opearation and new features which were not available at the time the
device was produced.
It may occur that after a software update some of your user defined settings like
network parameters or favourite stations are lost and have to be restored after
the update.
Updating the firmware via the R 1000 E’s Internet connection
The basic requirement is a functioning network with router and access to a
broadband Internet connection; the system must be operating.
Switch the machine on.
Call up the system configuration menu by pressing the button on the
front panel.
Use the / buttons to select the “Device info” menu item,
and confirm your selection by pressing the button.
Select the “Update” menu point with the / buttons, then
press the button to confirm your choice.
The Select option “WEB” should now be active (highlighted).
The firmware update can now be started by pressing .
The screen displays the current state of progress of the update.
Once the update has been completed (duration around ten minutes) the
device automatically switches itself off and restarts.
When the machine has restarted, the update is complete.
To ensure that the update was successful, access the “Device Info” menu
point mentioned above, and check the new firmware status.
It is also possible to carry out the update process using the FM1000 remote
control handset, as an alternative to operating the machine directly.
To Next Page
Loading...