T+A V10 User Manual

Using the system for the first time
Once you have completed the wiring of the system,
please set the volume control to a very low level before
turning on the mains switch located on the
amplifier’s back panel.
Switch on the other units in the system.
Turn on the amplifier using the main switch on the front
panel, then select a listening source.
When the power-on delay period has elapsed, the
loudspeaker outputs are switched on automatically and
you will hear the signal from the selected source.
Remove the strip of insulation from the battery
compartment of the F10 remote control handset.
Note:
If you encounter problems when setting up and using
the amplifier for the first time please remember that the
cause is often simple, and equally simple to eliminate.
Please refer to the section of these instructions entitled
'Trouble shooting'.
39

T+A V10 Specifications

General

Brand	T+A
Model	V10
Category	Amplifier
Language	English