27 |
Scope of supply
• 1 heavy weight support tool
• 1 fixture screw
Specications
Material: Stainless steel and plastic
Dimensions : 94x50x50 mm
(adjustable hight: 50 - 75 mm)
Mass: 14 g
When using top heavy tools the risk exists for a
tool to tip over due to the load, or the used
speed. Instable tools cause irregular wear and will
lead to non-reproducible results. A tipped over
tool can significantly scratch the sample and
damage it beyond use. The heavy weight support
tools are used to stabilize the tools by creating a
fixture point on the vertical axis of the tool. Per
tool 1 heavy weight support tool is required.
When a lighter weight is used, mount the
supplied spacers between the weight and the
tool.
10.4.11 Heavy Weight Support Tool (AB5032)
Scope of Supply
• AB5115 General tubing set
• 1 set of tubes suitable for installation between container
and pump and from the pump to the test area’s
• AB5113 Pump tubing kit
• 4 tubes for installation in the pumps
Specications
Pump tubing: BPT Pharmamed tube
Tubing to pump
and from pump : Tygon (at delivery PVC tube to the
pump)
Additional information
Waste / drainage
tube : Silicon tube
The TQC Scrub, Abrasion and Washability Tester
AB5000 and AB5005 are equipped with pumps
for the application of test liquids to the samples.
These tubes do require maintenance and timely
replacement depending on the liquids that are
pumped. The chemical resistance of the tubes is
covered in the chemical resistance table. The wear
of the tubes depends both on the abrasiveness
and aggressiveness of the media used. It is not
possible to predict the life expectancy of a
tube.
10.4.12 Tubing (AB5115 and AB5113)
To Next Page
Loading...