4T-V8-SF-1M-EN
17
SENSORS
Compressor Dome Temperature
This table shows the corresponding voltage, resistance
and temperature readings for the Dome Temperature
Sensor when measured across pins 1 and 10. The
power source for the Dome Temperature Sensor is
3.2VDC.
7(03 ) 7(03 &
7+(50,6725
5(6,67$1&(
๎2+06๎
92/76 '&
๎3,1 72 3,1๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎๎๎๎ ๎๎๎๎
๎๎ ๎๎๎๎๎๎ ๎๎๎๎๎๎ ๎๎๎๎
๎ ๎๎๎๎๎๎ ๎๎๎๎๎ ๎๎๎๎
๎ ๎๎๎๎๎๎ ๎๎๎๎๎ ๎๎๎๎
๎๎ ๎๎๎๎๎๎ ๎๎๎๎๎ ๎๎๎๎
๎๎ ๎๎๎๎๎ ๎๎๎๎๎ ๎๎๎๎
๎๎ ๎๎๎๎๎ ๎๎๎๎๎ ๎๎๎๎
๎๎ ๎๎๎๎๎ ๎๎๎๎๎ ๎๎๎๎
๎๎ ๎๎๎๎๎ ๎๎๎๎๎ ๎๎๎๎
๎๎ ๎๎๎๎ ๎๎๎๎๎ ๎๎๎๎
๎๎ ๎๎๎๎ ๎๎๎๎๎ ๎๎๎๎
๎๎ ๎๎๎๎ ๎๎๎๎๎ ๎๎๎๎
๎๎ ๎๎๎๎๎ ๎๎๎๎๎ ๎๎๎๎
๎๎ ๎๎๎๎๎ ๎๎๎๎๎ ๎๎๎๎
๎๎ ๎๎๎๎๎ ๎๎๎๎๎ ๎๎๎๎
๎๎ ๎๎๎๎๎ ๎๎๎๎๎ ๎๎๎๎
๎๎ ๎๎๎๎๎ ๎๎๎๎๎ ๎๎๎๎
๎๎ ๎๎๎๎๎ ๎๎๎๎๎ ๎๎๎๎
๎๎ ๎๎๎๎๎ ๎๎๎๎ ๎๎๎๎
๎๎ ๎๎๎๎๎ ๎๎๎๎ ๎๎๎๎
๎๎ ๎๎๎๎๎ ๎๎๎๎ ๎๎๎๎
๎๎ ๎๎๎๎๎ ๎๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
7(03 ) 7(03 &
7+(50,6725
5(6,67$1&(
๎2+06๎
92/76 '&
๎3,1 72 3,1๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
๎๎๎ ๎๎๎๎๎๎ ๎๎๎ ๎๎๎๎
Figure 6. Dome Temperature Sensor
Pin 1 & 10 (Red)
Integrated Variable Speed Control Board
J1
123456789
101112131415161718
A working Compressor Dome Temperature Sensor is
required for:
โข Protection (High/Low Temperature)
โข Preheating (Sump Heat)
โข Outdoor EEV Control
โข Diagnostics; Reverse rotation, Flooding, Charge
Level
The Dome Temperature Sensor control contains an
NTC thermistor input for sensing the Compressor
Dome Temperature. The thermistor has a nominal
resistance of ยง 10k ohms at 75ยฐF. The minimum range
required for the Dome Temperature input is โ31ยฐF to
302ยฐF. when measured across pins 1 and 10.
NNoottee:: Secure Installation of Dome Sensor is required
for reliable compressor & system operation.