Page 28
Installer’s Guide
Figure 25. 208/230 Volt Speed Taps
LOAD
BLOWER
LOAD
INDUCER
YL
(CC1) RD
RD
(IDM) PR
PARK
IN
IN
( CC1) RD
LOAD
BLOWER
LOAD
INDUCER
YL
(CC1) RD
RD
(IDM) PR
PARK
IN
IN
( CC1) RD
Hi Speed Tap
Setting
Low Speed Tap
Setting
(IGN) PR
P
H
L
IDM
BK
HI
LOW
RD
PR
ORANGE
YELLOW
BLACK
(IGN) PR
P
H
L
IDM
BK
HI
LOW
RD
PR
ORANGE
YELLOW
BLACK
B
B
D
D
C
C
Figure 26. 460 Volt Speed Taps
Hi Speed Tap Setting
Low Speed Tap Setting
Trane
6200 Troup Highway
Tyler, TX 75707-9010
The manufacturer has a policy of continuous product and product data improvement.
It reserves the right to change design and specification without notice.
Important Product Information
Registering your products helps provide you with one of the strongest manufacturer limited warranties available. To register, go to the
manufacturer’s website or contact your dealer. You will need the serial number, model number, and installation date for each product
being registered. Your dealer may have included these on your invoice or can provide a list for you to use. Please take a few moments to
record the following information to ensure your product registration process is quick and easy:
Packaged Unit Serial Number_____________________________________________________
Packaged Unit Model Number_____________________________________________________
Date of Installation______________________________________________________________
Dealer________________________________________________________________________
Service Information
Call your installing dealer if the unit is inoperative. Before you call, always check the following to be sure service is required:
a. Be sure the main switch that supplies power to the unit is in the ON position.
b. Replace any burned-out fuses or reset circuit breakers.
c. Be sure the thermostat is properly set.
Service Phone_________________________________________________________________
© 2014 Trane
04/14
To Previous Page
Loading...
