18-HE46D1-3 5
Installer’s Guide
9C) 460 Volt Heat Pump Models: See Figure 7
Disconnect the black fan motor lead from the fan relay
(terminal #6). Reconnect this black motor lead to the
black wire from the solid state relay on the control
module (This wire has a sleeved, 1/4" male tab for
attaching to the fan motor lead wire terminal).
Connect the other black wire from the solid state relay to
terminal #6 of the fan relay (from where the fan motor
wire was disconnected).
Low voltage wires:
Connect the 3-pin wire assembly to J5 on the control
board (3-pin male connector).
NOTE:
To ease the insertion of the connector housing onto
the J5 header, place the connector on the tips of the
three header pins. Angle the connector upward toward
the header latch while pushing connector over the
header pins.
Connect the yellow lead wire to a 1/4" male tab on the
right hand side of the main contactor (low voltage
contactor coil terminal).
Connect the blue lead wire to the wire nut junction of the
blue wire.
Connect the orange lead wire to the wire nut junction of
the orange wire.
(New wire nuts are provided.)
460 VOLT HEAT PUMP
7
To Next Page
Loading...
Need help?
General
