42 UNT-SVX07A-EN
installation
procedureInstallation
Note: The trim ring assembly cannot
accomodate unlevel ceilings.
Figure I-IP-1. Installing the trim ring assembly on horizontal recessed units.
Note: On sizes 8, 10, & 12 center installa-
tion position and use 2 or 3.5-inch bolts,
whichever is best suited for installation.
Also, install two safety chains assemblies
on these sizes.
Note: Expansion collar is furnished with
fan-coil with bottom return only. The
collar is not necessary for Force Flo units.
CAUTION
Unit Leveling!
All unit panels and filters must be in
place prior to unit start-up. Failure to
have panels and filters in place may
cause motor overload.
To Next Page
Loading...
