To Next PageTo Next Page
Need help?Do you have a question about the Trane GAM5A0A24M21SAA and is the answer not in the manual?
General| Model Number | GAM5A0A24M21SAA |
|---|---|
| Category | Air Handlers |
| Voltage | 208/230V |
| Phase | 1 |
| Maximum External Static Pressure | 0.8 in. w.c. |
| Cabinet | Galvanized Steel |
| Blower Type | Multi-speed |
| Nominal Cooling Capacity | 2 Tons |
| Nominal Heating Capacity | 24000 BTU/H |
Covers hazards like live electrical components, hazardous vapors, sharp edges, and general safety.
Warns against using the unit during finishing phases to prevent corrosion from environmental contaminants.
Instructions for disassembling the unit cabinet for installation in confined or tight areas.
Table detailing vapor and liquid line connection sizes for various GAM5 air handler models.
Detailed instructions for safely brazing refrigerant lines to the unit's internal connections.
Instructions for routing control wiring, removing coil panel, and preparing for connections.
Diagrams illustrating wiring connections for cooling and heat pump system operation.
Procedures for securing wiring harnesses and configuring the refrigerant type switch.
Steps for sliding the control plate into the pocket and replacing the coil access panel.
Procedures for routing high voltage wiring and selecting appropriate conduit entry points.
Explains unit operation in various modes like cooling, heating, and continuous fan with EVC and TDR functions.
A comprehensive checklist to verify proper installation, wiring, and system performance.
