To Next PageTo Next Page
Need help?Do you have a question about the Trane GAM5A0C60M51SAA and is the answer not in the manual?
Covers hazards like sharp edges and general installation risks to ensure installer safety.
Critical safety measures for working with live electrical components to prevent severe injury or fatality.
Addresses risks from hazardous vapors and corrosion from condensate, advising on proper installation locations.
Table listing vapor and liquid line connection sizes for each indoor unit model number.
Diagram illustrating the placement of key refrigerant system parts like sensors, EEV, and strainer.
Detailed instructions for brazing, including panel removal, protecting components, and making connections.
Table specifying maximum wire lengths for 18, 16, and 14 AWG low voltage wiring based on voltage.
Steps for routing control wiring, removing the coil panel, and preparing for low voltage connections.
Diagrams and notes for connecting low voltage wiring for cooling operation between the air handler and thermostat.
Wiring diagrams and operational sequences for heat pump systems in cooling and heating modes.
Ensures high voltage power matches the nameplate and complies with all applicable electrical codes.
A checklist of critical checks for proper installation and operation, including suspension, insulation, electrical, and ductwork.
General| Product Category | Air Handler |
|---|---|
| Model Number | GAM5A0C60M51SAA |
| Nominal Capacity (tons) | 5 |
| CFM | 2000 |
| Nominal Airflow | 2000 cfm |
| Motor Type | PSC |
| Voltage | 208/230 |
| Phase | 1 |
| Cabinet Construction | Galvanized Steel |
| Drain Pan | Plastic |
| Nominal Cooling Capacity | 60000 BTU/h |
| Insulation | Fiberglass |
